In this video, we'll walk you through the steps of prepping and cleaning your floor for DuraLabel PathFinder Floor Marking tape in order to mark a fire exit. Follow these steps to ensure your fire exits are easily identifiable and compliant with safety regulations.
Floor Marking Tape Prep and Cleaning Instructions:
Floor Preparation Instructions:
1. Clear out and block off the area where applying tape.
2. Sweep up any dirt or debris from the floor.
3. Clean the floor with a general cleaner (avoid citrus-based). Scrub with clean rag or brush.
4. After it�s dry, wipe the surface with Isopropyl alcohol to remove any leftover residue and let it dry.
Clean Floor Test:
1. Cut a small square of tape from your roll.
2. Stick to the floor for 10 seconds.
3. Peel off and check the adhesive side. If there�s dirt or debris, repeat floor preparation steps until the clean.
Timestamps:
0:07 Part I: Clean & Prep
0:13
What Happens If You Don't Clean Your Floor?
0:22
Step 1: Clean & Sweep Area
0:26 Step 2: Clean Floor with General Non-Citrus Based Cleaner
0:32 Step 3: Use Isopropyl Alcohol to clean leftover residue
0:40
Step 4: Check if Floor is Dry
0:45
Step 5: Test for Clean Floor
0:51 Ready to Apply Floor Tape