Lockout Tagout Sequence| LO/TO | Equipment Safety | DuraLabel

The following is a transcript of the Sample Lockout Sequence Infographic:

Lockout/Tagout

Sample Lockout Sequence

Before servicing equipment that could cause injury if it started up without warning, turn it off, shut down the power, and keep it off until the service is done. That's lockout/tagout (LO/TO) in a nutshell. This example sequence shows a step-by-step LO/TO process that can be easily adapted for any equipment in your facility.

LOCKING OUT EQUIPMENT

Before starting service on equipment:

1. Notify all affected employees that the equipment will be locked out
2. Identify all energy types and sources in use
3. Shut down the equipment normally
4. Isolate the equipment from its energy sources
5. Lock out the energy isolating devices
6. Remove or restrain any remaining energy
7. Confirm that the equipment is unpowered

Now that the equipment is locked out, you can begin service.

RETURNING TO NORMAL WORK:

Once the service work is done, but before resuming normal work:

1. Check the equipment and area for loose parts or tools
2. Make sure all workers are in safe places
3. Verify that the equipment controls are in "off" or "neutral"
4. Remove lockout devices and reconnect energy sources
5. Notify all affected employees that the equipment will be starting up again
6. LO/TO procedure is complete; normal work may resume